Quote:
Originally Posted by Cyclops
not really in detail but did post some detials on my garage journal thread
V groove casters running on an angle iron that was cut into the Swisstrax floor so it sits flush with the floor. I had custom aluminum plates fabricated for the pads. My initial calculations were wrong and the aluminium bent up more then expected so now I have and get the ramps bent down a little more.
Now I just got to figure out how to motorize it. I was thinking using a winch motor and some type of screw or worm drive. |
Wow that's Impressive!! And now for the obligatory silly comment: If you manage a setup like the old Green Hornet had, I'll be blown away!
