View Single Post
      09-04-2012, 09:00 AM   #7
gmd2003
Colonel
gmd2003's Avatar
352
Rep
2,176
Posts

Drives: 2014 CP M6 and 2006 VT 525 Z4M
Join Date: May 2012
Location: South Carolina

iTrader: (2)

Quote:
Originally Posted by Mirko View Post
Was it a simple bolt up for the E60 oil cooler? How much modification required? Please post up some pictures if you have them.
It took custom brackets and custom A/N fittings for the braided oil lines . It definitely was a one off job that's why i was fortunate for someone else to have done it before. Here is the link to that build by Fluid Motorunion. They still had the schematics so they were able to whip another setup up for me.These pics are much better than mine but its the exact setup minus the extra power steering cooler that this guy set up. Best mod i have done so far will definitely greatly increase the life of my motor given the hard usage it sees. It also increases the oil capacity by almost a liter which helps reduce the work cycle of the oil as well as the obvious temp benefits.
http://www.fluidmotorunion.com/archives/8186
Appreciate 0