|
Strong-Strut installation
Just finished installing my Strong-Strut tower bar and firewall braces.
I did not run into any problems with the tower mounting hardware clearing the firewall brace attach point, they laid even & flat. Used 1 washer for each acorn nut, as specified.
On the Firewall braces however, I installed the 2 washers per stud that were supplied, screwed on the acorn nuts to hand-tight and there was a pretty big gap between the nut and the washers. I don't know if the stud would actually have bottomed in the acorn nut, but decided to add a third washer...everything tightened up fine.
Overall very nice!!
|