Quote:
Originally Posted by racerbruce
Thank you grannyknot -
Is this posted per request of a fellow Zposter?
|
No, I just thought someone else might need it at some point, it was hard won.
I'm not much of an electronic/computer guy and it took me a couple weeks to track down this info.
I'm trying get coolant temp and oil pressure readings into the cab where I can see them, I could just plumb in water temp and oil pressure sensors but I was hoping I could tap into those wires that feed into the DME.
I think I can use the signal from the existing coolant temp sensor but the oil pressure sensor is just a switch that tells the DME that there is pressure so it is safe to start the engine, don't think it is relaying data on how much pressure.