Quote:
Originally Posted by in2twins
Wondering if I should have ordered 5mm spacers for the front???
I ended up ordering 18x9.5 ET35 Apex PS-7 with PSS 265-35-18 square.
12mm spacers in the rear
No spacer in the front.
75mm studs
This will be my street set-up.
I am looking for input on the best way to adjust the front camber without plates. I.E. Turner, H&R or?
Thanks, Carl
|
Go with the
Turner bolts and shims, or see if the
Bimmer World E36 camber shim kit will fit. You'll get much more camber shimming the lower mounting points than you will with the smaller "camber bolts" that go into the upper mount point. They typically only give you about +/- 0.25 degrees adjustment.