View Single Post
      10-31-2012, 01:34 PM   #92
mike519
Captain
 
mike519's Avatar
 
Drives: 2006 Z4MR Sepang
Join Date: Apr 2012
Location: Waterloo, Ontario

Posts: 701
iTrader: (0)

Quote:
Originally Posted by Joe@ApexRaceParts View Post
You could very easily use our most concave profile 3 wheel in the rear of your car. Either an 18x9.5" ET22 with a 265/35/18 tire or an 18x10" ET25 with a 275/35/18 tire could be used as a direct fitment.

For the front I would recommend our 18x8.5" ET35 wheel with a 235/40/18 tire. This is indeed a profile 1 wheel but in person they do have some concavity compared to pictures on the internet. Unfortunately it is very hard to fit a concave wheel on the front of a Z4M without camber plates. To give a comparison our 18x9" ET31 wheel is narrower than the normal 18x9.5" ET35 front wheel set up that most track guys will run but, the 18x9" ET31 will sit at almost the same point relative to the fender as the 18x9.5" ET35 so camber plates are also necessary for that wheel even with a narrower tire.
Excellent info, thanks
mike519 is offline   Canada
0
Reply With Quote